ODROID C4 4GB, emmc 8GB

Predam ODROID-C4 4GB, vratane emmc modulu 8GB, plne funkcne a bez poskodenia. Moznost dual-boot coreelec z sd karty a android tv z emmc modulu.

Po dohode mozem doniest do BA, PK, SC, TT, DS, GA, NR alebo okolie, pripadne poslat za doplatok na dobierku cez packetu.

PARAMETRE:

Specifications
Form factor Board Dimensions: 85mm x 56mm x 1.0mm
Heatsink Dimensions: 40mm x 32mm x 10mm

Weight: 59g including heatsink

Processor Amlogic S905X3 12nm Processor
L1 instruction cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor

L1 data cache: 32 KB, 4-way set associative (128 sets), 64 byte lines, shared by 1 processor

L3 data cache: 512KB , 16-way set associative (512 sets), 64 byte lines, shared by 4 processors

Quad-Core Cortex-A55 (2.016GHz)

ARMv8-A architecture with Neon and Crypto extensions

Mali-G31 MP2 GPU with 4 x Execution Engines (650Mhz)

Memory DDR4 4GiB with 32-bit bus width
Data rate: 2640 MT/s (PC4-21333 grade)

1.2Volt low power design

Storage 1x eMMC connector (8/16/32/64GiB are available)
1x Micro SD slot (DS/HS mode up to UHS-I SDR104)

Networking 1 x GbE LAN ports (RJ45, supports 10/100/1000 Mbps)
– Realtek RTL8211F (Ethernet transceiver)

– LED indicators

* Green LED: Flashing by data traffic at 100Mbps connection

* Amber LED: Flashing by data traffic at 1000Mbps connection

Optional WiFi USB adapters

Video 1 x HDMI 2.0 (up to 4K@60Hz with HDR, CEC, EDID)
Audio 1 x HDMI digital output
1 x Optional SPDIF optical output

External I/O 4 x USB 3.0 Host ports (shares one single root hub)
1 x USB 2.0 OTG port for Host or Device mode. (No power input)

1 x Debug serial console (UART)

1 x Peripheral Expansion Header (40-pin, 2.54mm pitch)

2x DC 5V, 2x DC 3.3V, 1x DC 1.8V, 8x GND
1x SPI
1x UART
2x I2C
6x PWM
2x ADC input (12bit, 1.8V Max)
25x GPIO (Max)
1x Audio Expansion Header (7-pin, 2.54mm pitch)

1x DC 5V
1x SPDIF out
1x I2S
– All 3.3V I/O signal level except for ADC input at max 1.8Volt.

Other features IR receiver for remote controller
System LEDS Indicators:

– Red (PWR) – Solid light when DC power is connected

– Blue (ALIVE) – Flashing like heartbeat while Kernel is running.

Power 1 x DC jack : outer (negative) diameter 5.5mm, inner (positive) diameter 2.1mm
DC input : 5.5V ~ 13V (*15V/4A PSU is not compatible with C4)

– DC 12V/2A power adaptor is recommended

Power consumption:

– IDLE : ≃ 1.8W

– CPU Stress : ≃ 3.64W (Performance governor)

– Power-off : ≃ 0.14W